<html><body>This is cool! Currently I have 8 beaglebone blacks and a small Atom blade as the introducer and helper. I am looking for people to connect to my grid for testing. I even took the hard drive out of the introducer and one node formated them and put tahoe 1.10 i was able to repair the grid no prob. <i><br><br>On 16/10/13 01:28:54,<br>Garonda Rodian <deepside@hotmail.com> wrote:<br></i><blockquote style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(200, 200, 200); padding-left: 1ex;"><div dir='ltr'>My ODROID-U2, Debian Wheezy, LXFE has successfully arrived, booted from MicroSD, and run.<br><br>python setup.py build failed just after it didn't find tahoe-deps, until I installed my usual set of packages (including, but not limited to, python-dev), after which it worked fine. <br><br>python setup.py trial succeed with 6 skipped and 2 expected failures in something over 1500 seconds, typically using 100% of one out of four cores, and the maximum amount of total RAM in use I happened to see (htop) was on the order of 561MB - since it has 2GB of RAM, that's more than fine.<br><br>Further testing to follow - I have high hopes it can serve as an introducer + storage nodes, or even a helper/client gateway. If I can get a Gigabit USB2 card working, perhaps it'll even break the 10MB/s limit as a storage node!<br> </div><blockquote /></body></html>